Table of Contents
Advertisement
Power-adapter port
Removing the power-adapter port
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
3. Remove the
display
assembly.
4. Remove the
integrated heat sink
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Steps
1. Peel the tape that secures the power-adapter port cable to its connector on the system board.
2. Disconnect the power-adapter port cable from its connector on the system board.
3. Peel the tape that secures the power-adapter port cable to the palm-rest and keyboard assembly.
4. Remove the power-adapter port cable from the routing guides on the palm-rest and keyboard assembly.
5. Lift the power-adapter port and its cable off the palm-rest and keyboard assembly.
Installing the power-adapter port
CAUTION:
The information in this section is intended for authorized service technicians only.
68
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
or
discrete heat sink
computer.
Before working inside your
Advertisement
Table of Contents
