Installing The Touchpad - Dell Inspiron 14 Plus 7430 Owner's Manual

Steps
1. Open the latch and disconnect the touchpad cable from its connector on the touchpad.
2. Open the latch and disconnect the touchpad cable from its connector on the system board.
3. Lift the touchpad cable off the system board.
4. Peel the adhesive tape that secures the speaker and antenna cables onto the touchpad.
5. Remove the four screws (M2x2) and the five screws (M1.6x2.5) that secure the touchpad bracket to the palm-rest and
keyboard assembly.
6. Lift the touchpad bracket off the palm-rest and keyboard assembly.
7. Lift the touchpad off the palm-rest and keyboard assembly.

Installing the touchpad

Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing Field Replaceable Units (FRUs) 81