Sbpl (Only Available On Ezs Version Firmware) - TSC PEX-2000 Series User Manual

5.2.3 SBPL Only available on EZS version firmware)
(
Setting
Item
This item is used to set the print mode. There are three modes as below,
Dispenser
Print Type
Rewinder mode
Continuous
Use this item to setup printing darkness. The available setting range is from 0 to
Print Darkness
10. You may need to adjust your density based on selected media.
Use this item to setup print speed. Available setting range is 2~18 for 203dpi and
Print Speed
2~14 for 300dpi
Slew Speed Use this item to setup feed speed. Setting value is up to 8 ips.
BackFeed Speed Use this item to setup back feed speed. Setting value is up to 6 ips.
Use this item to adjust the offset position. Offset adjusts the back/feed/stop
Offset
position for Tear-off/Cut/Dispense operation.
Use this item to adjust the leading edge of media position thus effects the vertical
Pitch
print position placement.
Print Type
Print Darkness
Print Speed(S)
SBPL Slew Speed(S)
BackFeed Speed(S)
Offset
Pitch
Description
Once printer complete printing 1 label, it will wait for being
removed.
The print engine prints without pausing between labels.
The media is wound onto a core after printing.
Print the specified number of media
Dispenser
Rewinder
Mode
Continuous
203 dpi: 6 ips
300 dpi: 4 ips
203 dpi: 6 ips
300 dpi: 4 ips
Default
Dispenser
3
2 ips
0 dot
0 dot
53