Table of Contents
Advertisement
B
Appendix
Loading Flash Memory
Table 16. Flash Memory Message Guide
Message
CLEARING PROGRAM
FROM FLASH
DIAGNOSTIC
PASSED
ERROR: DC
PROGRAM
NOT VALID
ERROR: DRAM AT
ADDRESS XXXXXXXX
ERROR: EC
PROGRAM
NOT VALID
ERROR: EC STOPPED
AT STATE XXXX
ERROR: FLASH
DID NOT PROGRAM
ERROR: NO DRAM
DETECTED
216
Explanation
The program successfully loaded
into printer RAM and the checksum
matched. The old program is now
being deleted from flash memory.
The printer passed its memory and
hardware initialization tests.
Printer cannot find the data controller
program or the validation checksum
is corrupt.
The printer found a defective
memory location.
Printer cannot find the engine
controller program or the validation
checksum is corrupt.
Hardware fault in the engine
controller.
The printer encountered an error
trying to program flash memory.
The printer could not find any
DRAM.
Required Action
None
None
Download the
program again. If the
message occurs
again, call your
service
representative.
Call your service
representative.
Download the
program again. If the
message occurs
again, call your
service
representative.
Call your service
representative.
Download the
program again. If the
message occurs
again, call your
service
representative.
Call your service
representative.
Advertisement
Table of Contents
