Table of Contents
Advertisement
B
Appendix
Loading Flash Memory
6. Connect the parallel data cable to the default parallel port (LPT1) of
an IBM or IBM-compatible personal computer using the PC-DOS,
MS-DOS, Windows 3.x or Windows 95 operating system.
NOTE: You can connect the cable to the LPT2 port if the LPT1 port is
7. Connect the parallel data cable to the parallel port of the printer.
8. Plug the AC power cord into the printer.
9. Power on the host computer.
10. Insert the emulation or upgrade diskette into diskette drive A (or B)
of the personal computer.
11. Make the diskette drive the active drive by typing the following at
the DOS prompt:
A:<Return>
(If the diskette is in drive B, type B:<Return>)
12. Get the name of the compressed file on the diskette by listing the
contents of the diskette; at the DOS prompt type:
DIR<Return>
The compressed file on the diskette takes the form FILENAME.EXE
Write down the complete name of the file with the . EXE extension.
13. On the printer operator panel, press and hold down the ON LINE +
FF keys. Without releasing the keys, power the printer on. Continue
holding the keys down until "WAITING FOR PROGRAM
DOWNLOAD" appears on the LCD.
14. When you see "WAITING FOR PROGRAM DOWNLOAD" on the
LCD, release the ON LINE + FF keys.
NOTE: The default download port is DATAPRODUCTS; this is the
15. Press the
PORT=DATAPRODUCTS" appears on the LCD.
16. Press
available in the printer:
DATAPRODUCTS*
RS232-9600
RS232-19.2K
214
already in use. You can also download software through the
printer serial port. The download commands are different if you
use these ports, as described in the note after step 18.
standard download through the parallel port. If you want to use
the default, continue with step 18.
<
(NEXT) key; "SELECT DOWNLOAD
<
(NEXT) again to cycle through the download ports
(parallel) (default port)
(RS-232 serial, 9600 baud)
(RS-232 serial, 19200 baud)
Advertisement
Table of Contents
