Steps
1. Adhere the coin-cell battery to the system board.
2. Connect the coin-cell battery cable to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
I/O board
Removing the I/O board
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the io board and provides a visual representation of the removal procedure.
54
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.