Dell Inspiron 16 5635 Owner's Manual page 65

Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Gently place the palm-rest and keyboard assembly under the display hinges.
3. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and
keyboard assembly.
4. Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.
5. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the palm-rest and
keyboard assembly.
6. Replace the three screws (M2.5x5) to secure the right display hinge to the palm-rest and keyboard assembly.
7. Connect the display cable to the system board and close the latch.
8. Adhere the tape to secure the display-cable connector latch to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Field Replaceable Units (FRUs) 65