Table of Contents
Advertisement
Steps
1. Using the alignment posts, place the speakers on the palm-rest and keyboard assembly.
2. Ensure that the alignment posts are routed through the rubber grommets on the speaker.
Note
3. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
4. Adhere the tapes to secure the WLAN cable to the system board.
5. Connect the keyboard cable to the system board and close the latch.
6. Connect the touchpad cable to the system board and close the latch.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the coin-cell battery and provides a visual representation of the removal
procedure.
52
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
