Dell Inspiron 16 5635 Owner's Manual page 57

2. Remove the base cover.
About this task
NOTE: Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the power button with fp and provides a visual representation of the removal
procedure.
Steps
1. Remove the two screws (M2.5x5) that secure the left display hinge to the system board.
2. Open the left display hinge at an angle of 90 degrees.
3. Open the latch and disconnect the power-button board cable from the I/O board.
4. Open the latch and disconnect the finger-print reader cable from the power-button board.
5. Remove the two screws (M2x3) that secure the power-button board to the palm-rest and keyboard assembly.
6. Lift the power-button board off the palm-rest and keyboard assembly.
7. Lift the power button with optional fingerprint reader off the palm-rest and keyboard assembly.
Removing and installing Field Replaceable Units (FRUs) 57