Heat Sink; Removing The Heat Sink - Dell Inspiron 16 5635 Owner's Manual

Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
2. Replace the five screws (M2x4) to secure the battery to the palm-rest and keyboard assembly.
3. Route the battery cable through the tabs and reconnect it to the system board.
4. Adhere the tape that secures the battery cable to the battery
Next steps
1. Install the base cover.
2. Follow the procedure in

Heat sink

Removing the heat sink

Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the base cover.
About this task
NOTE: Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the heat sink and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 47