Table of Contents
Advertisement
Next steps
1. Install the
wireless
card.
2. Install the
M.2 2230 solid-state drive
3. Install the
heat
sink.
4. Install the
base
cover.
5. Follow the procedure in
Touchpad
Removing the touchpad
Prerequisites
CAUTION:
The information in this section is intended for authorized service technicians only.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
About this task
NOTE:
Before removing the base cover, ensure that there is no SD card installed in the SD card slot on your computer.
The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.
Steps
1. Open the latch of the touchpad connector and disconnect the touchpad cable from the touchpad.
2. Remove the five screws (M2x2) and seven screws (M2x1.8) that secure the touchpad bracket to the palm-rest and
keyboard assembly.
3. Lift the touchpad bracket off the palm-rest and keyboard assembly.
4. Lift the touchpad assembly off the palm-rest and keyboard assembly.
72
Removing and installing Field Replaceable Units (FRUs)
or
M.2 2280 solid-state
After working inside your
Before working inside your
drive, whichever applicable.
computer.
computer.
Advertisement
Table of Contents
