Installing Your New Recorder; Basic Connections - JVC HR-S9600EU Instructions Manual

4
EN
Ba sic
Connections
Aerial terminal
Back of TV
21-pin SCART Cable
Mains Power
Cord
Mains outlet
Make AV connection if your TV has a 21-pin AV input
connector (SCART) in order to reduce the possibility of
interference. And if you are using a stereo TV, you will need
this cable in order to enjoy stereo playback of videotapes.
AV1 IN PU T/ O U TPU T SIGN AL SELECTIO N FO R AV CO N N ECTIO N
The AV1 IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in
which the luminance and chrominance signals are separated). For input signal selection, select "VIDEO" (regular video signal) or
"S-VIDEO" (Y/C signal) for "AV1 SELECT" setting (
● If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP .
● If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high-
quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)
N O TES:
● Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.
● For switching the TV's mode, refer to the instruction manual of your television.
● To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 5.
Downloaded from: https://www.usersmanualguide.com/
21-pin SCART
connector
TV Aerial
Cable
RF Cable
(provided)
AV1 OUT AV1 IN/OUT
switch
IN STALLIN G YO U R N EW RECO RD ER
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
CHECK CO N TEN TS
Make sure the package contains all of the accessories
1
listed in " Specifications" (
SITUATE RECO RDER
Place the recorder on a stable, horizontal surface.
2
CO N N ECT RECO RDER TO
TV
The connection method you use depends on the type of
3
TV you have.
RF CO N N ECTIO N
● To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
c– Connect the provided RF cable between the RF
AV CO N N ECTIO N
● To Connect To A TV With AV Input Terminals . . .
a– Connect the aerial, recorder and TV as per " RF
b– Connect an optional SCART cable between the
c– Set the AV1 OUT switch to the appropriate position.
CO N N ECT RECO RDER TO
MAIN S
Rear view
Plug the end of the mains power cord into a mains
4
outlet.
After you plug the mains power cord into a mains outlet, the
Country Set display appears on the TV screen and/or on the
recorder's front display panel when the
recorder/remote control is pressed for the first time to power
on the recorder; go to page 6 to perform Auto Set Up.
pg. 44). For output signal selection, use AV1 O U T switch of the rear panel.
pg. 75).
on the rear panel of the recorder.
OUT jack on the rear panel of the recorder and the
TV's aerial terminal.
CONNECTION" .
AV1 IN/OUT socket on the rear panel of the
recorder and the TV's 21-pin SCART connector.
See "AV1 INPUT/OUTPUT SIGNAL SELECTION
FOR AV CONNECTION" below.
button on the