JVC HR-S9600EU Instructions Manual page 60

60
EN
Set Sta tions (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 58 to access the Confirmation screen before continuing.
SELECT ITEM
Press %fi
1
@ #
ACCESS MAN UAL
CHAN N EL SET SCREEN
Press O K twice.
2
SELECT N EW ST ATIO N
Press until the station
3
#
name (ID) begins blinking,
then press %fi until the
new station's name (ID)
you want to store begins
blinking.
Registered station names
( pg. 61) appear as you
press %fi .
SW ITCH ST ATIO N S
Press O K .
4
● The Confirmation screen appears.
● Repeat steps
CLO SE CO N FIRMATIO N
SCREEN
Press M EN U .
5
Downloaded from: https://www.usersmanualguide.com/
until the item you want begins blinking.
PR CH ID
06 CH45 – – – – +/–
[ 5 ∞ ] : CHANGE ID
[ ] : CURSOR +=
: OK
[MENU] : EXIT
1 through 4 as necessary.
SU BSID IARY SETTIN GS (cont.)
Set Sta tions (B)
Set station names other than the ones registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 58 to access the Confirmation screen and then perform
step 1 and 2 of "Set Stations (A)" on the left before continuing.
SELECT ST ATIO N N AME
CHARACTER
Press
1
of the station name begins
blinking.
EN TER N EW CHARACTER
Press %fi to cycle through the characters (A–Z, 0–9, –,
2
FINE DECODER
*
OFF
is indicated, then press
characters the same way (maximum of 4).
After entering all characters, press O K .
● The Confirmation screen appears.
● If you make a mistake, press
CLO SE CO N FIRMATIO N
SCREEN
Press M EN U .
3
until the first letter
#
PR CH
06 CH45 ARD
[ 5 ∞ ] : A-Z, 0-9
[
[MENU] : EXIT
, +, (space) ) and stop when the desired character
to enter. Enter the remaining
#
character begins blinking. Then enter the correct
character by pressing %fi .
ID FINE DECODER
+/– OFF
] : CURSOR +=
: OK
until the incorrect
@