JVC HR-S9600EU Instructions Manual page 47

1 3
2
1
2
0000
Downloaded from: https://www.usersmanualguide.com/
– –:– –
1 2 3
4 5 6
7 8 9
3
4
0
4
3
1
2
PLAY
EN GAGE IN SERT EDITIN G
Press IN SERT .
6
8
● Your recorder enters the Insert-Pause mode. (" ", " "
and " " light up on the front display panel.)
● The TV screen changes from the still picture to the
input source you are going to record.
ST ART EDITIN G
Load the source cassette and play back the segment that
7
is to be inserted. When you reach the start of the
section of the source tape that you wish to insert, press
PLAY to start the tape in your recorder; Insert Editing
begins at this point.
● " " and " " are displayed on the front display panel.
EN D IN SERT EDITIN G
At counter "0:00:00", Insert Editing will stop automati-
8
cally while the tape continues running in the Play
mode. If you wish to stop Insert Editing before the
specified edit-out point, press 0000 (or C.RESET/
CAN CEL ).
FO R AV IN SERT EDITIN G
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
... In step
6 above, after you press IN SERT , press A. D U B also.
(" " and " " blink and " " lights up on the front display
panel.)
N O TES:
● Suitable leads can be obtained from your dealer.
● Insert editing is not possible with cassettes whose safety tab
has been removed.
● When insert editing is performed on a tape that has been
recorded on another video recorder, the inserted portion may
appear distorted.
● In insert editing, the recording speed (SP/LP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point.
● A small portion of the recording which precedes an insert edit
may become erased.
● Insert Editing is also possible using the rear panel AV1 IN/
OUT or AV2 IN/DECODER connector. When using these
connectors, make sure to select the correct input mode in step
2 .
47
EN