Always use caution when using flammable substances such as benzene, alcohol and LP gas. (Failure to do so can result in a fire hazard.) Prevent foreign substances from contacting the door seal. (The inflow of outside air can negatively impact the temperature in chamber.) NB-T101S / T101SRC (Ver.2018.12) 3/16...
Page 4
Install the instrument on a flat and stable surface, free from vibration and in a well-ventilated location. (If the surface is not level, it can cause an excessive vibration of the product.) NB-T101S / T101SRC (Ver.2018.12) 4/16...
- In case of cable connection on remote control box, please find hollow from both cables as below. Both hollows should be connected otherwise both connectors are not well fit to each other. - Do not connect or disconnect when remote box power is on. NB-T101S / T101SRC (Ver.2018.12) 7/16...
N-BIOTEK www.n-biotek.com 3.2 Strap installation * Insert the both edge of plastic strap into vent hole of remote control box. <Hanging with Hook> <Attachment with magnetics> *Hook is not a standard component. NB-T101S / T101SRC (Ver.2018.12) 8/16...
(Or wait 5 seconds for the value to store automatically) ⓔ Exit: If you press after changing any values, the values are not saved and the screen returns to the previous ⓓ ⓔ ⓒ screen NB-T101S / T101SRC (Ver.2018.12) 9/16...
NOTE: To return to the BASIC View, TOUCH “MENU” and choose the BASIC View. Shaker View Shaking Speed The ADVANCED View provides the user with access to the STEP mode for linking consecutive mixing cycles. Time 00 : 00 : 00 NB-T101S / T101SRC (Ver.2018.12) 10/16...
Page 11
ⓓ ⓔ ⓔ Exit: If you press button, the changed setting values are not saved and the screen turns to the previous screen. NB-T101S / T101SRC (Ver.2018.12) 11/16...
Page 12
Shaking Speed ▷ Alarm Disabled The alarm can be disabled by TOUCHING and holding the key for 3~5 seconds. To reactivate the alarm setting, Time 00 : 00 : 00 TOUCH the once. NB-T101S / T101SRC (Ver.2018.12) 12/16...
ⓗ There are 3 modes available for Step Operation : “One cycle”, “Repeat Cycle”, “Step off” ⓔ ⓕ NOTE: Repeat cycle will result in continue repeating of all programmed steps until the stop button is pressed. ⓗ NB-T101S / T101SRC (Ver.2018.12) 13/16...
Page 14
DO NOT attempt to operate the unit until the spillage had been properly dried. ▶Service and Contact Service on the MINI SHAKER AND REMOTE SHAKER WITH TOUCH PANEL<CE> should only be performed by qualified service personnel. To request service or technical support, please contact your local N-BIOTEK representative. NB-T101S / T101SRC (Ver.2018.12) 14/16...
N-BIOTEK, whichever is sooner as indicated in above table. This period is proved by serial no. 3. N-BIOTEK will not be responsible of free warranty service for the faulty caused by user’s improper operation, excessive use, use of incorrect voltage & frequency, storage in wrong environment mentioned in Manual.
Need help?
Do you have a question about the NB-T101S and is the answer not in the manual?
Questions and answers