The default network type of InSight is dynamic.
If you have a DHCP server, it will automatically set the InSight.
Step
2
IP address settings
If you do not have a DHCP server, it will set as follows after one minute.
Initial address: Refer to the label on the InSight
User name: root
Default password: OPTEX
Change your password as appropriate.
Download IP installer;
https://navi.optex.net/firmware/50427
Refer to the InSight Camera manual for more details.
Step
3
Device registration to CHeKT portal
Setup your CHeKT Dealer Portal:
1. Go to http://dealer.chekt.com/ to log in.
2. Select the Customer on the left side of the dashboard.
3. Select the Site Devices tab.
4. Select the bridge device to be associated with the sensor camera.
5. Access the bridge settings using the gear icon to its right.
6. Select the appropriate tab to register the PIR camera.
Refer to the CHeCK support site for more details.
Step
Jump to
3
InSight Camera manual
https://navi.optex.net/manual/50427/en/?type=cameramanual/
https://support.chekt.com
5
CHeKT support