INS-CUBE
INS-CUBE
VISUAL VERIFICATION PIR CAMERA
<< Contents >>
Before installation
- Manufacturer's statement
- Parts identification
- Accessories
- CHeKT account
Step
1
Installation
1-1. Install the mounting bracket
1-2. Remove the main unit from the base unit
1-3. Install/Remove an SD Memory Card
(optional)
1-4. Wiring
1-5. Mounting body
1-6. Secure the main unit to the base unit
Enable
DHCP
Disable
2
IP address settings
For more information about Camera
setting, see our website.
www.optexamerica.com
CHeKT support
https://support.chekt.com
3
Registration InSight to CHeKT portal site
4
Testing
4-1. Walk test and camera angle checking
4-2. System test
Others
- Specifications
- LED indications
- Dimensions
- Detection area
- Compliance
series
Before installation
- Manufacturer's statement
Page
1
Warning
Failure to follow the instructions provided with this indication and improper
Caution
2
handling may cause injury and/or property damage.
Prohibition
Warning
3
Destroy
/Modify
Detection through glass
Caution
4
1
INSTALLATION INSTRUCTIONS
Full information is available at
https://www.optexamerica.com
•
This "Quick Guide" is the part of the entire installation instructions
that guides the installation procedures for installers.
•
Get the full information of the installation instructions from the web site.
•
If you need a guide to the operation of the whole system, please
consult the installer of the entire system.
Failure to follow the instructions provided with this indication and improper
handling may cause death or serious injury.
Recommendation
Outdoor installation
Mounting height
2.0 to 3.0 m (6'7" to 9'8")
3.0 m (9'8") recommended
Quick Guide
Special attention is required to the
NOTE
section of this symbol.
Wetting with water
Partial/complete obscuration
of the detection area.
Tilt
Follow to the Regulations