Advertisement
DIFFERENTIALS
23) Tighten the side bearing retainer bolts.
Lock Tite:
THREE BOND 1105 (Part No. 004403010) or
equivalent
Tightening torque:
10.3 N·m (1.05 kgf-m, 7.6 ft-lb)
24) Install the new gasket and rear cover and tight-
en the bolts to specified torque.
Tightening torque:
29 N·m (3.0 kgf-m, 21.7 ft-lb)
25) Install the breather cap.
26) Install the drain plug and filler plug.
Tightening torque:
49 N·m (5.0 kgf-m, 36.2 ft-lb)
2. STi MODEL
1) Precautions for assembling
• Assemble in the reverse order of disassembling.
• Check and adjust each part during assembly.
• Keep the shims and washers in order, so that
they are not improperly installed.
• Thoroughly clean the surfaces on which the
shims, washers and bearings are to be installed.
• Apply gear oil when installing the bearings and
thrust washers.
• Be careful not to mix up the right and left hand
races of the bearings.
REAR DIFFERENTIAL
• Replace the oil seal with a new one at every dis-
assembly. Apply chassis grease between the lips
when installing the oil seal.
• Adjust the bearing preload with spacer and
washer between front and rear bearings. Pinion
height adjusting shim are not affected by this ad-
DI-00098
justment. The adjustment must be carried out with-
out oil seal inserted.
2) Press-fit the rear bearing race into differential
carrier using ST.
ST 398417700
DI-00113
3) Press-fit the front bearing race into differential
carrier using ST.
ST 398477702
DI-38
DRIFT
ST
DRIFT
DI-00078
DI-00318
DI-00319
Advertisement
