Advertisement
5) Press-fit the front bearing cone into case with
ST1, ST2 and ST3.
ST1 398507703
DUMMY COLLAR
ST2 399780104
WEIGHT
ST3 899580100
INSTALLER
ST3
ST1
ST2
6) Insert the spacer, then press-fit the pilot bearing
with ST1 and ST2.
ST1 399780104
WEIGHT
ST2 899580100
INSTALLER
ST2
ST1
7) Fit a new oil seal with ST.
NOTE:
• Press-fit until the end of oil seal is 1 mm (0.04 in)
inward from end of carrier.
• Apply grease between the oil seal lips.
ST 498447120
INSTALLER
ST
REAR DIFFERENTIAL
8) Press-fit the companion flange with ST1 and
ST2.
NOTE:
Be careful not to damage the bearing.
ST1 899874100
ST2 399780104
DI-00087
9) Install a new self-locking nut. Then tighten it with
the ST.
ST 498427200
Tightening torque:
181 N·m (18.5 kgf-m, 134 ft-lb)
DI-00088
10) Assembling differential case
Install the side gears and pinion mate gears, with
their thrust washers and pinion mate shaft, into dif-
ferential case. (Model without LSD)
NOTE:
• Apply gear oil on both sides of the washer and on
the side gear shaft before installing.
DI-00089
DI-33
DIFFERENTIALS
INSTALLER
WEIGHT
ST1
ST2
DI-00090
FLANGE WRENCH
ST
DI-00091
Advertisement
