Table of Contents
Advertisement
7
Mechanical installation
7.1
Requirements
7.2
Assembly
Version: 1.0
All work should be carried out with great care and without time pres-
sure.
When designing and dimensioning the machine or system, observe
the basic requirements for mounting the magnetic encoder system.
Use only the drill holes shown
Use only the drill holes shown for the assembly or for other activi-
ties described in these operating instructions. Drill holes not shown
may be present, for example, for production purposes.
Failure to do so will result in damage to the magnetic encoder sys-
tem or the motor.
Clean the mounting surfaces
Make sure that all mounting surfaces are oil-free, grease-free and
unpainted. Remove any dirt or dust.
Observe the mounting sequence
Mount the AL8200 magnetic encoder system only after all steps of
the AL8000 assembly have been completed.
Observe the screw requirements
Observe the minimum and maximum screw depths of the screws.
Information on the screw depths can be found in the individual sec-
tions during mounting. Please observe the permissible torques and
standards.
The MES is installed behind or in front of the primary part, so that it
moves with the primary part over the secondary part.
Screw quality = strength class 8.8
Screw
Screw depth
Tightening torque
Locating pin according to ISO 8734
Nominal diameter
Screw depth
AL8200
Mechanical installation
M4
4 - 4.5 mm
2 Nm
5 mm
4 - 4.5 mm
───
27
Advertisement
Table of Contents
