Fault Checking - Mistral DRINKPAD Manual

Compressor does not start
No current
The thermostat is in off position, or set to low
The thermostat is defective
The starting relay is faulty
The starter capacitor is defective
The compressor is defective
The compressor works continuously, but the water is not
cold
The ice bank is empty
There is no ice in the ice bank
There is a gas leak from refrigerant circuit
The compressor is defective
The water is cold but the appliance is working excessively
There is not enough ventilation
Pipes touch the body and cause vibrations
The pressure of water is too low and pump makes noise
Cold water comes out gently
The water filter is blocked
The solenoid valve is defective
The water inlet pressure is too low
The water coil is blocked with ice
Sparkling version
Sparkling water is low carbonated
Sparkling water is low carbonated (2)
The temperature of the outlet water is not enough cold
There is air in the carbonator
Only gas is dispensed through the outlet of sparkling water
Level sensors are dirty
The pump is running continuously there is water in the inlet
The safety of the pump has been activated (no water)
The cold water comes out carbonated
MAINTENANCE

FAULT CHECKING

Check the voltage
Adjust the position of the thermostat
Replace the thermostat
Replace
Replace
Contact a refrigeration technician
Check, fill
Waiting for ice forming
Contact a refrigeration technician
Contact a refrigeration technician
Move device away from wall
Adjust the position of the pipes
Increase the water pressure
Check, replace
Check, replace
Check, adjust pressure reducer
Check the agitator, the thermostat
The CO2 pressure is set to less than 3.5 bar > check and adjust
The bottle of CO2 is empty > check and adjust
Set the thermostat to maximum (clockwise)
Purge the carbonator
Control, disassemble and clean
Check Level Controller
Disconnect and reconnect the watercooler
The carbonator check valve is dirty
> disassemble and clean OR replace
23