Water Distribution - Mistral DRINKPAD Manual

Distribution buttons
2

Water distribution

First choose the water you want by pushing on the corresponding button, from 1 to 4 (see below chart).
To start dispensing water, press the Play/Pause button. (N°5).
Stay pressed to fill up your container and release the button to stop distribution.
Water distribution with automatic dosage option
Choose the water you want by pressing the corresponding button.
To trigger distribution, press briefly on the Play/Pause key and release it. The quantity of water set will run automatically.
Note: if you want less water than the set quantity, press again briefly on the Play/Pause key when you need the distribu-
tion to stop.
A long press on the Play/Pause button (> 2sec.) allow water to run until button is released.
Choose automatic dosage or classic distribution
1. Open the top
2. Press for 7 sec. on the Reset button (Figure 1) until the first 3 operating indicators appears: Water, UV and Drip-tray
(Figure 2).
3. Release the Reset button: the Ambient and Sparkling water distribution buttons are lighted up, you have 5 seconds
to choose.
4. To switch in automatic dosage mode, press on the Sparkling water key. To exit the automatic dosage mode and swit-
ch to the classic distribution mode, press on the Tempered water key.
WARNING: if the dosage mode is on, there is a default preset of 5 seconds of distribution
Automatic dosage mode : set / modify water volume related to a selection
1. Press and hold the distribution you want to program for 10 seconds.
2. Once the button stop blinking, place your container and press and hold the Play key to run water.
3. Once the button is released, the programming is done (the time left pressed corresponds to the time you want to
program)
Note: each type of water has its own programming. The maximum programmable time is 4 min10.
USER GUIDE
1
3 4
5
Figure 1
Keys
N° 1
N°2
N°3
N°4
N°5
Figure 2
15
Link
Hot water
Ambient water
Cold water
Sparkling water
Distribution button (Play/
Pause)