Before Starting Installation - Mistral DRINKPAD Manual

Installation and maintenance operations must only be done by a qualified person.
Contact the service or company in charge of maintenance for any interventions.
During water coolers installation, Mistral recommend to replace the supply hose by a new one or to disinfect the device
with an antibacterial product like Sanipure which reduces the risks of bacterial proliferation.
A disinfection operation of internal pipes must be operated at the installation, during interventions on the hydraulic system
and, at least, once a year.

Before starting installation

The location must allow sufficient ventilation, make sure there is enough space for ventilation - at least 40cm.
Water connection : make sure there is, close to the water cooler, on its left or right side, a shut-off valve with a 3/4''
(20/27) female outlet.
Electrical connection : make sure there is, close to the water cooler, on its left or right side, a 220V socket with a 10A
circuit breaker.
Our water cooler bear a water pressure between 3 and 4 bars maximum.
Connection of the Watersafe® anti-leakage system: allow approx. 10cm between the machine and the water connection,
if the water inlet is positioned at the back of the fountain.
Before disinfecting the water cooler, read carefully the manufacturer's instruction and put on all personnal protective
equipments. This operation must only be done by a qualified person.
Before any maintenance or cleaning operation, disconnect the water cooler.
The water cooler must be disconnected before starting installation.
The drip tray must be installed only once the fountain has been placed on its base.
1. Installation kit
• Installation manual
• Watersafe® - Antileak system
• 1power cord
• 2m of John Guest blue pipe to keep for filter purging and maintenance.
• Sparkling version : 1 regulator and manometer for CO2 cartridge. Connector for big cartridge.
• Connector for reusable CO2 cartridge.
2. If your model has a base, unscrew the 4 jacks feet and place the water cooler so that the holes in the feet corres-
pond with the hole in the top of the base. To help you do so, use the stop to position the fountain on its base. Then,
fix the water cooler on the base with the 4 feet that screw together.
3. Draining : see chart for the different versions
INSTALLATION
16