Maintenance - Husqvarna CT 36A Operator's Manual

Note:
The period of time between troweling
operations is calculated from how quickly the concrete
sets.
To move the product in different
directions
• To turn to the left, lift the handle.
• To turn to the right, push the handle down.
Introduction
WARNING:
safety chapter before you perform the
maintenance on the product.
WARNING:
maintenance on the product, stop the
product and make sure that all parts of
the product are cool. Refer to
product on page 15 .
Put the product on a flat surface.
1452 - 003 - 30.01.2023

Maintenance

Read and understand the
Before you perform the
To stop the
• To move the product forward, push the handle
forward.
• To move the product rearward, pull the handle
rearward.
To stop the product
1. Move the throttle control to the idle speed position.
2. Push the stop button for the engine. Refer to
overview on page 3 .
3. Set the engine ON/OFF switch to the OFF position.
4. Move the fuel valve to the OFF position.
For all servicing and repair work on the product, special
training is necessary. Professional repairs and servicing
is available. If your dealer is not a service agent, speak
to them for information about the nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
Product
15