Husqvarna CT 36A Operator's Manual page 18

a) A-V models:
b) All other models:
3. Slowly turn the pulley while you remove the belt from
the pulley.
CAUTION:
clutch or the pulley when you replace
the belt. The clutch and the pulley are
aligned at the factory.
4. Install a new belt.
18
Do not remove the
5. Install the belt cover, the washers and the screws.
Torque the screws to 5 Nm/3.7 lb-ft.
To lubricate the blade shafts
• Push grease through the grease nipples until grease
comes out around the blade shafts. Refer to
Technical data on page 25 .
To replace the blades
WARNING:
blades, stop the product, make sure that the
engine is cool and remove the spark plug
cable.
WARNING:
1. Remove the screws (A) and remove the blades.
2. Apply grease to the threads of the screws to make
the removal of the screws easier the next time.
3. Install the new blades.
Before you replace the
Use protective gloves.
A
1452 - 003 - 30.01.2023