AEG CGB6130ACM User Manual page 10

WARNING!
Only a qualified and competent person
can do the gas installation.
Before you connect te gas, disconnect
the appliance from the electricity supply
or switch off the fuse in the fuse box.
Close the primary valve of the gas
supply.
Supply piping should not be less than
R3/8. Connection is made to the Rc 1/2
(1/2 " B.S.P.) female threaded. The entry
pipe is located just below the hob level
on the rear left hand side of the
appliance.
The gas supply ramp is on the rear side
of the appliance.
WARNING!
Only liquid sealants can be used when
the inlet gas pipe is fitted i.e.: do not use
the P.T.F.E. sealant tape.
When the installation is complete, carry
out a gas tightness test and make sure
that the seal of each pipe fitting does not
leak.
Use flexible tubing, which comply with
the BS.669 current edition.
A
B
C
10 ENGLISH
The gas bayonet connector must be in
the marked area.
Dimension
A
B
C
D
E
3.8 Pressure test
The Rapid injector is used as a pressure test
point.
1. Connect the pressure gauge to the Rapid
2. Examine the supply pressure by turning
3. Turn the taps off and disconnect the
4. Make sure that all burners work correctly.
3.9 Checking the hob burners
1. Lift the lid.
2. Put on the burner crowns and caps. Make
3. Put on the pan supports.
4. Light one of the hob burners.
5. Turn the knob for the hob to the off
E
3.10 Checking the oven burners
1. Put in the deep pan and the trivet.
D
2. Light the oven burner.
C
3. Turn the knob to the off position.
3.11 Checking the Lid Safety Device
1. Lift the lid.
WARNING!
injector.
the Rapid burner and one other burner
fully on, and lighting them. The pressure
must be 20 mbar for Natural Gas.
pressure gauge.
sure that they are correctly seated.
To light the hob burner refer to the
"Ignition of the hob burners".
Check if the flame is regular.
Check each of the burners.
position.
To light the oven burner refer to the
"Ignition of the oven burners".
Check if the flame is regular.
mm
250
680
50
250
580