Download Print this page
Front Runner Slimline II KRVA002T Quick Start Manual

Front Runner Slimline II KRVA002T Quick Start Manual

Roof rail rack kit for volkswagen atlas (2018-current)

Advertisement

Quick Links

front runner
START HERE!
Don't be a hero and muscle through this installation without reading these fitting instructions first! Improper installation of this gear may void certain
aspects of your warranty.
Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components.
A complete kit will contain:
1. A Front Runner Mounting System specific to your vehicle
2. A Front Runner Rack Tray or Load Bar Slats
This document will guide you through the assembly of the mounting system and assist you in fitting the roof rack tray or load bars to your specific
vehicle.
Please refer to the next page for a list of all the components, quantities and tools required.
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
KRVA002T_REV_A00
VOLKSWAGEN ATLAS (2018-CURRENT)
SLIMLINE II ROOF RAIL RACK KIT
READ ME FIRST
IMPORTANT WARNING!
Please call us if you have any questions about the installation of this product.
1
KRVA002T
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
ENG

Advertisement

loading

Summary of Contents for Front Runner Slimline II KRVA002T

  • Page 1 Don’t be a hero and muscle through this installation without reading these fitting instructions first! Improper installation of this gear may void certain aspects of your warranty. Before you begin, take a moment and open all your Front Runner rack kit boxes and gather the assembly instructions for the various components. A complete kit will contain: 1.
  • Page 2 GET ORGANIZED IN THE BOX TOOLS NEEDED Slimline II Tray - 1255mm(W) X 1560mm(L) Spacer Set Grab On Foot Set Inner Grip Set 13mm Outer Grip Set FIGURE 1.1 KRVA002T_REV_A00 © 2021 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 3 Loosely assemble the two Grab On Foot Sets (Item 3) onto the slats indicated in 2.2 as shown using M8 Flat Washers and M8 Nyloc Nuts. Note the Spacers must be used on the rear feet. KRVA002T_REV_A00 © 2021 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 4 Grab On Foot using a M5 Cap Screw, M5 Spring Washer and M5 Cap Screw Washer removed. Inner Grip Outer Grip FIT AND SECURE Make sure that the wind deflector is installed before you proceed to the next step. KRVA002T_REV_A00 © 2021 FRONT RUNNER VEHICLE OUTFITTERS...
  • Page 5 IMPORTANT! FRONT RUNNER RACK KITS OFTEN HAVE A HIGHER LOAD RATING THAN THE VEHICLES THEY ARE MOUNTED TO. PLEASE REFER TO YOUR SPECIFIC VEHICLE MANUFACTURER FOR A RECOMMENDED ROOF RATING. FRONT RUNNER CANNOT BE RESPONSIBLE FOR IMPROPER LOADING BEYOND THE VEHICLE MANUFACTURER'S STATED LOAD CAPACITY.