Operating The Machine - Komatsu 730E Operation & Maintenance Manual

OM2036 06/06
In The Operator's Cab - Before Starting The
Engine
• DO NOT leave tools or spare parts lying around
or allow trash to accumulate in the cab of the
truck. Keep all unauthorized reading material out
of the truck cab.
• Keep the cab floor, controls, steps, and handrails
free of oil, grease, snow, and excess dirt.
• Check the seat belt, buckle, and hardware for
damage or wear. Replace any worn or damaged
parts. Use the seat belts when operating a
machine.
• Read and understand the contents of the
Operation and Maintenance manual. Read the
safety and operating instructions with special
attention. Become thoroughly acquainted with all
the gauges, instruments, and controls before
operating the truck.
• Read and understand the warning and caution
decals in the operator's cab.
• Ensure the steering wheel, horn, controls, and
pedals are free of any oil, grease, or mud.
• Check the windshield wiper, the condition of the
wiper blades, and the washer fluid reservoir level.
• Be familiar with all steering and brake system
controls, warning devices, road speeds, and
loading capabilities before operating the truck.

OPERATING THE MACHINE

Starting The Engine
• DO NOT attempt to start the machine by shorting
across the starter terminals. This may cause a
fire, or serious injury or death, to anyone in the
machine's path.
• Check for people and objects that remain on or
around the truck.
• DO NOT start the engine if a warning tag has
been attached to the controls.
• When starting the engine, sound the horn as an
alert.
• Start and operate the machine only while seated
in the operator's seat.
• DO NOT allow any unauthorized persons in the
operator's compartment or any other place on the
machine.
• For machines equipped with a back-up alarm,
check that the alarm works properly.
Truck Operation - General
• Wear seat belts at all times.
• Only authorized persons are allowed to ride in
the truck. Passengers must be in the cab and
belted in the passenger seat.
• DO NOT allow anyone to ride on the decks or on
the steps of the truck.
• DO NOT allow anyone to get on or off the truck
while it is in motion.
• DO NOT move the truck in or out of a building
without a signal person present.
• Know and obey hand signal communications
between the operator and spotter. When other
machines and personnel are present, the
operator must move in and out of buildings,
loading areas, and through traffic, under the
direction of a signal person. Courtesy at all times
is a safety precaution!
• Immediately report any adverse conditions on the
haul road, pit, or dump area that may cause an
operating hazard.
Safety - Section 20
Page 20-5