Setting The Time - Komatsu 730E Operation & Maintenance Manual

Radio / Cassette Player - Section 70
Page 70-2

SETTING THE TIME

1. Turn the key switch ON.
2. Press and hold DSPL/TM SET (9, Figure 70-1)
for two seconds. When the number display
flashes, time set mode is active.
3. Press TUNE / SEEK
hour setting.
4. Press the DSPL/TM button to switch to minutes.
The minute digits will flash when in this mode.
5. Press TUNE / SEEK
setting.
After five seconds of inactivity, the display will return
to the default mode. The clock will now display the
correct time of day.
OPERATING THE RADIO
BAND
Press BAND (2, Figure 70-1) to switch between FM1,
FM2, AM, and WX Weather (US) and Satellite (XM1,
XM2 or SR1, SR2). If a separate satellite receiver is
not connected to your radio and operational, the sat-
ellite bands will not appear in the display.
TUNE/SEEK
TUNE (7) / SEEK (8) allows you to move up or
down in frequency to other stations. There are two
modes of operation for finding other stations, manual
tuning and seek mode.
Press and hold both TUNE (8) and BAND (2) for
two seconds to toggle between the two modes. The
display will read either MANUAL or SEEK to indicate
the mode the receiver is in.
Manual Tuning
Press TUNE (8) to tune to the next higher fre-
quency. Press SEEK (7) to tune to the next lower
frequency. Holding either of the buttons for more
than 0.5 seconds will activate fast tuning for
increased speed.
When in satellite mode, press and release either the
TUNE or the SEEK buttons to navigate to the
next channel. Pressing and holding either of the two
buttons for more than 0.5 seconds will increase the
cycle speed through the channels. The increase
cycle speed is approximately 10 channels per sec-
ond.
(7 & 8) to change the
to change the minute
SEEK Mode
Hold either the TUNE or SEEK
than 0.5 seconds to enter the seek mode. SEEK will
appear on the display when this mode is activated. In
this mode, the radio will scroll through stations and
stop on the next station with a strong signal.
NOTE: If the receiver can not find a strong enough
signal after two band cycles, the seek mode will
discontinue and the receiver will return to the initial
starting point.
When in satellite mode, press
navigate through the channels. Pressing and holding
either of the two buttons for more than two seconds
will increase the cycle speed through the channels.
The increase cycle speed is approximately 10 chan-
nels per second.
SCAN
Press SCAN button (10) to scan all stations on the
current band. When a strong frequency is found, the
receiver will pause on that station for about five sec-
onds and then continue scanning. Scan will appear
on the display along with the frequency when this
mode is active. To stop scanning, press the SCAN
button again.
AUTO
AUTO (12) allows the receiver to store the six stron-
gest stations onto push-buttons 1 through 6. Press
AUTO until AUTO and AS appear on the display. The
presets on the current band only will now be pro-
grammed with the six strongest frequencies. Presets
on the other inactive bands will not be changed.
Pressing AUTO again will delete the stations and
default to the original preset stations.
NOTE: The AUTO function is not functional on the
satellite band.
OM7004 4/05
buttons for more
TUNE or SEEK to