How To Change The Language - Oilon EasyAce Operation Manual

Domestic hot water
Electric immersion heater A heating cartridge built into a domestic hot water tank or heating circuit
Flow
Flow temperature
Heating circuit
Heating curve
Heating water
In-line heater
Outdoor temperature
Room optimization

1.4 How to change the language

1. Open the main menu from the top left corner or
by swiping right from the left edge of the screen.
3. Select Language and location.
5. Select the language from the list.
4 (49)
Hot tap water.
buffer tank. Provides supplementary heating or acts as a backup heater.
In heating circuits, 'flow' refers to water that has been heated up by the heat
pump and fed into the heating circuit. In the brine circuit, 'flow' refers to brine
returning from the heat pump to the brine circuit.
Temperature in a fluid fed into a circuit (water in heating circuits, brine in the
brine circuit).
A circuit that transfers the heat generated by the heat pump to radiators or
floor heating pipes. A building can have several heating circuits – one for
living areas and another for wet spaces, for example.
A six-point curve that determines the heating provided by the heat pump at
different outdoor temperatures.
Water heated up by the heat pump and used for heating the domestic hot
water tank or a heating circuit buffer tank. If the heat pump is connected
directly to a heating circuit (without a buffer tank), heating water is used to
heat the heating circuit (as 'flow' water).
An electric heater cartridge built into or connected to a fluid line. In Oilon heat
pumps, an in-line heater is often built into the condenser flow pipe to provide
supplementary heating or to act as a backup heater.
Outdoor temperature is the primary control variable in space heating; it
determines how much heating will the heat pump provide.
A feature that adjusts the heat pump's operation based on measured room
temperature. Heat pump operation is still dependent on outdoor temperature
and heating curves.
2. From the menu, select App settings.
4. Select Application language.
6. Check that the language in the
User interface menu is also correct.
M8004 2308EN