Miele PRI 210 Operating Instructions Manual page 36

Cleaning and care
Fold the ironer waxing cloth.

Start the waxing programme (see "Cleaning and care - Starting the waxing programme").

Feed in the ironer waxing cloth into the ironer with the rubber-coated side facing the

roller.
Feed the ironer waxing cloth multiple times into the ironer from the left or right side at the

necessary intervals across the entire working width of the ironer. If no damp patches can
be seen on the ironer waxing cloth after it has passed through the ironer, add additional
ironing wax.
On ironers with feed-in belts, ensure that no ironing wax comes into contact with the
belts.
Otherwise the feed belts may become too smooth and can no longer be driven properly.
When finished, press and hold the  sensor for a minimum of 3 seconds.

The waxing mode is deactivated.
- After waxing, feed a cotton cloth through the ironer in order to remove wax residues.
- To maintain the smooth surface of the heater plate, it should be waxed after every
working day.
Always carry out cleaning in the cleaning programme and waxing in the waxing
programme, as otherwise the ironer's maintenance interval will not be reset. The
maintenance interval is only reset once cleaning and waxing have been carried out for at
least 40 seconds in the corresponding mode.
36
1 .
2 .
3 .