Starting The Waxing Programme - Miele PRI 210 Operating Instructions Manual

The heater plate must be waxed after every cleaning process.
You can then switch directly to the waxing programme by pressing the temperature
selection sensor  on the right or exit the cleaning programme by pressing and holding
the  sensor for at least 3 seconds.

Starting the waxing programme

Press and hold the  sensor for at least 3 seconds.

2 temperature selection sensors which do not take the form of temperature dots (e.g. )
are displayed.
To start the ironer waxing programme, press the temperature selection sensor on the

right.
The ironer will then switch to the waxing programme.
To deactivate the waxing programme, press the  sensor and then keep the  sensor
pressed for at least 3 seconds.
When the ironer has reached a temperature of 180 °C, the  sensor begins to flash. The
waxing programme is then ready to begin.
Press the flashing  sensor to start the waxing programme.

The heater plate can then be waxed using the ironer waxing cloth.
If waxing has been successfully carried out in the waxing programme for a period lasting
at least 40 seconds, the maintenance interval for prompting the cleaning and waxing of
the heater plate (indicated by a red symbol ) will be reset.
Using the ironer waxing cloth and ironing wax
Sprinkle some ironing wax into the pocket of the ironer waxing cloth.

Use the ironing wax sparingly to prevent the roller cover around the roller from becoming
too smooth.
Cleaning and care
180 °C is shown in the display.
35