Table of Contents
Advertisement
Message
Ribbon cassette isn't set.
End of media.
Pull out print media
Replace print media.
End of ribbon.
Replace ribbon cassette.
Start of media not detect.
Remove media between
print head and cutter.
Print head position can't be
initialized.
Print head can't be moved to
print position.
Cut position can't be
initialized.
Size switch lever is not
positioned correctly.
Proceed?
Data check.
Resetting completely
Details/Solution
Load the ribbon cassette. Press the [Enter] key to resume
(P.18)
printing.
The print media ran out during printing. Pull out the print
media from the printer and press any key. Replace the print
media with a new one and press the [Enter] key to resume
printing from the interrupted page.
Load a new print media and press the [Enter] key to resume
(P.21)
printing.
Replace the ribbon cassette with a new one and press the
[Enter] key to resume printing from the interrupted page.
Remove the print media and make sure that the print media
is not stuck between the print head and the cutter. For
information on removing print media from between the
print head and cutter, refer to
Becomes Jammed (P.206)"
correctly, press the [Enter] key to resume printing.
Press any key. If the same message appears again, contact
your place of purchase.
The size of the print media set on the printing preference
display does not match the position of the size switch lever.
(P.22)
If you select "Yes, " printing will start.
To reset the settings, select "No" and follow the instructions
on the screen to set the size switch lever to the correct
position. Press any key to start printing.
An error has occurred in the data and all settings have
reverted to the settings at the time of purchase. All saved
fi les have also been deleted.
219
(P.21)
"If a Tube or Label Tape
. After setting the print media
Advertisement
Table of Contents
