Table of Contents
Advertisement
Problem
Characters are squashed
or blurred.
The surface of the print
media is dirty after
printing.
Out of ribbon
White vertical lines
appear when printing on
the plate.
I cannot select a print
media other than "Plate"
in the print settings.
Cause/Things to Check
Are you printing small or
complicated characters?
Ink may stick to the ribbon due
to the top of the print media
touching the ribbon during
printing.
There is a sticky stain on the
tube that looks like the glue
from plastic tape.
The print density may not be
appropriate.
Some pages are set to
"Expansion" in the Plate Print
Area.
214
Solution
Adjust the print density.
(P.90)
Use a dry cloth to wipe off any
dirt on the print media.
Use a clean tube.
Adjust the print density to
match the print result.
• If black fi lled symbols ( ,
, etc.) cause streaks (lines),
reduce the density.
• If lines appear on characters
or symbols other than the
above, increase the density.
Set the Plate Print Area to
"Normal" or set the Cut Length
(P.55)
to "Automatic. "
(P.90)
Advertisement
Table of Contents
