Advertisement
Figure 4 Removing an LSWM2XGT2PM interface card
Verifying the installation
After the installation is complete, identify whether the interface card is
operating correctly according to the status of the 1/10GBase-T port
LEDs.
If the interface card fails to operate correctly, perform the following
steps:
1. Reinstall it following the installation procedures described in this
document.
2. If the problem persists, contact HPE Support.
▌Documentation
To access documentation and support services, go to the Hewlett
Packard Enterprise Support Center website:
www.hpe.com/support/hpesc
5998-7834s
© Copyright 2015 Hewlett Packard Enterprise Development LP
The information in this document is subject to change without notice.
BOM: 3101A0JL
Version: 6PW103
6
Advertisement
