Installing The Interface Cable In A Pga Socket Assembly - HP 10312D Operating Manual

Installing the
lnterf ace Cable in
a PGA Socket
Assembly.
To connect the microprocessor connector to the target system:
1. Remove the 80286 microprocessor from the target system
microprocessor socket.
2. Store the microprocessor in a protected environment.
3. Place the interface connector (see figure 1-2), attached to the end of
the cable from the interface module, in the target system
microprocessor socket.
Take care to align the interface connector with the target
system socket so that all microprocessor contacts are making
contact. Also, take care to note the position of pin 1 on both
the connector and socket prior to inserting the connector in
the socket.
Note
If necessary, the socket protectors may be removed from the
top and bottom of the interface connector to reduce
capacitance or to improve clearance by providing a lower
profile. Their removal, however, increases the risk of
damaging a pin or trace on the interface connector, so remove
the connectors only when absolutely necessary.
Analyzing the Intel 80286
1-7