Chapter Ix Describes The Configuration Of The Upper Computer - Ebyte E610-433T30S User Manual

433mhz 1w wireless high-speed connection module

Hide thumbs Also See for E610-433T30S:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd

Chapter IX describes the configuration of the upper computer



The following figure shows the display interface for configuring the upper computer on the E610-433T30S.

Users can switch to the command mode by using M0 and M1 to quickly configure and read parameters on the upper

computer.



In configuring the upper computer, the module address, frequency channel, network ID and key are displayed

in decimal mode. The value ranges of each parameter：

Network address：0～65535

Frequency channel：0～83

Network ID：0～255

key：0～65535



When configuring the trunk mode on the upper computer, you need to pay special attention to the fact that

the parameters on the upper computer are displayed in decimal mode, so the module address and network ID

need to be converted into decimal；

If the network ID entered by transmitter A is 02 and the network ID entered by receiver B is 10, the hexadecimal

value 0X020A is converted to the decimal value 522 as the module address entered by relay R when setting

the module address；

In this case, the module address to be entered by the trunk R is 522。

E610-433T30S User Manual

Table of Contents