Module Mode Switching Process; Notes - Ebyte E610-433T30S User Manual

433mhz 1w wireless high-speed connection module

Hide thumbs Also See for E610-433T30S:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd

5.6.5 Module mode switching process

The M0 and M1 hardware mode switching process is used：



1、The external interrupt of pins M0 and M1 is triggered；

2、AUX pull down the pin；

3、Exit the current task mode and read the pin level of M0 and M1 to judge the new mode；

4、

Enter the new mode task, pull up AUX, and complete mode switching (switching time is about 40ms).

Number

For function 1 and function 2 above, the output low level is preferred, that is, if any

output low level condition is met, AUX will output low level;

AUX outputs a high level when all low level conditions are not met.

When AUX output low power level, it indicates that the module is busy and the working mode

detection is not performed.

Mode switching will be completed within 1ms after AUX output high level.

After the user switches to the new working mode, the module will not enter the mode until

at least 2ms after AUX rises.

If AUX is always on high, then the mode switch takes effect immediately.

When the user goes from mode 3 (sleep mode) to another mode or during reset, the module

will reset the user parameters, during which AUX output is low.

AUX pin sequence diagram during module power-on initialization

AUX pin timing diagram when module switches mode

AUX Notes

E610-433T30S User Manual

Table of Contents