Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co., Ltd.
ADDH\ADDL of Repeater 1 are 08，33 respectively.
So the data sent by node 1 (08) can be forwarded to node 2 (33)
Meanwhile,node 1 and node 2 have the same address, so the data transmitted by node 1 can be received by node 2.
② Secondary repeater
ADDH\ADDL of Repeater 2 are 33，05 respectively.
Therefore, Repeater 2 can forward the data of Repeater 1 to the network NETID: 05.
Thus node 3 and node 4 can receive the data from node . Node 4 outputs data normally, but no ourput from Node3 because Node 3 has
a different address from Node 1.
③ Two-way repeater
As shown in below：The data sent by Node 1 can be received by Node 2 and Node 4; The data sent by by Node 2 and Node 4 can also
be received by Node 1.
Chapter 10 Configuration instructions on computer
The following figure is the display interface of E29-400T22S configuration on computer. User can switch to the command mode
through M0, M1, and quickly configure and read the parameters on computer. (配置软件要英文界面)
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
E29-400TXXX product data sheet
23
Advertisement
Table of Contents
