Configuration Instructions On Computer - Ebyte E22-400T22S1C User Manual

Chengdu Ebyte Electronic Technology Co., Ltd.
So the signal sent by node 1 (08) can be forwarded to node 2 (33)
At the same time, node 1 and node 2 have the same address, so the data transmitted by node 1 can be received by node 2.
② Secondary repeater
Secondary repeater's ADDH\ADDL are 33，05.
Therefore, Repeater 2 can forward the data of Repeater 1 to the network NETID: 05.
Thus node 3 and node 4 can receive node 1 data. Node 4 outputs data normally, and node 3 has a different address than node
1, so no data is output.
Two-way repeater
3
As shown in the figure: the data sent by node 1, the nodes 2, 4 can receive the data sent by node 2, 4, and node 1 can also

9 Configuration instructions on computer

The following figure shows the E22-400T22S1C configuration host computer display interface, the user can switch to the

command mode through M0M1, and quickly configure and read the parameters on computer.
Copyright ©2012–2018，Chengdu Ebyte Electronic Technology Co.,Ltd.
receive
it.
E22-400T22S1C User manual
19