Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd
Chapter Ⅷ Using the Trunk Networking Mode
Item
After the trunk mode is set in Configuration mode, the trunk starts to work when it is switched
1
to the common mode.
In relay mode, ADDH and ADDL are no longer used as module addresses, but are forwarded and paired
2
with NETID respectively. If one network is received, it is forwarded to the other network. The
network ID of the repeater itself is invalid.
3
In trunk mode, the trunk module cannot send or receive data and cannot perform low-power operations.
When entering from Mode 3 (sleep mode) to another mode or during reset, the module resets user
4
parameters, during which AUX output is low.
Description of trunk networking rules：
1、Forwarding rules. The trunk can forward data bidirectional between two NeTiDs。
2、In trunk mode, ADDH\ADDL serves as NETID instead of module address。
As the picture：
①Primary relay
"Node 1" NETID is 08。
"Node 2" NETID is 33。
ADDH\ADDL of Trunk 1 is 08,33 respectively.
So the signal sent by node 1 (08) can be forwarded to node 2 (33).
At the same time, node 1 and node 2 have the same address, so the data sent by node 1 can be received by node
2.
②Secondary relay
ADDH\ADDL of trunk 2 is 33,05 respectively.
Therefore, trunk 2 can forward data from trunk 1 to network NETID: 05.
Therefore, node 3 and node 4 can receive data from node 1. Node 4 normally outputs data. Node 3 and node 1 have
different addresses, so no data is output.
③Bidirectional relay
Configuration as shown in the figure: Data sent by node 1 can be received by nodes 2 and 4, and data sent by nodes
2 and 4 can also be received by node 1.
Copyright ©2012–2022,Chengdu Ebyte Electronic Technology Co.,Ltd
20
Trunk mode description
E610-433T30S User Manual
Advertisement
Table of Contents
