Configuration Instructions On Computer - Ebyte E22-900T30S1C User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd.

"Node 1" NETID is 08.

"Node 2" NETID is 33.

Primary repeater 1's 'ADDH\ADDL are 08，33.

So the signal sent by node 1 (08) can be forwarded to node 2 (33)

At the same time, node 1 and node 2 have the same address, so the data transmitted by node 1 can be received by node 2.

② Secondary repeater

Secondary repeater's ADDH\ADDL are 33，05.

Therefore, Repeater 2 can forward the data of Repeater 1 to the network NETID: 05.

Thus node 3 and node 4 can receive node 1 data. Node 4 outputs data normally, and node 3 has a different address than node

1, so no data is output.

Two-way repeater

As shown in the figure: the data sent by node 1, the nodes 2, 4 can receive the data sent by node 2, 4, and node 1 can also

9 Configuration instructions on computer

The following figure shows the E22-900T30S1C configuration host computer display interface, the user can switch to the



command mode through M0M1, and quickly configure and read the parameters on computer.

receive

it.

E22-900T30S1C User manual

Table of Contents