Epson SL-D500 Series User Manual page 114

SL-D500 Series User's Guide
❏ WEP-64 bit (40 bit)
❏ WEP-128 bit (104 bit)
❏ WPA PSK (TKIP/AES)*
❏ WPA2 PSK (TKIP/AES)*
❏ WPA (TKIP/AES)
❏ WPA2 (TKIP/AES)
❏ WPA3-SAE (AES)
❏ WPA2/WPA3-Enterprise
*: WPA PSK is also known as WPA Personal. WPA2
PSK is also known as WPA2 Personal.
E-6
Solutions:
❏ Check if MAC address filtering is disabled. If it is
enabled, register the printer's MAC address so that
it is not filtered. See the documentation provided
with the wireless router for details. You can check
the printer's MAC address from the Network
Status part on the network connection report.
❏ If your wireless router is using shared
authentication with WEP security, make sure the
authentication key and index are correct.
❏ If the number of connectable devices on the
wireless router is less than the number of network
devices that you want to connect, make settings
on the wireless router to increase the number of
connectable devices. See the documentation
provided with the wireless router to make settings.
Related information
"Connecting to a Computer" on page 106
U
E-8
Solutions:
❏ Enable DHCP on the wireless router if the
printer's Obtain IP Address setting is set to Auto.
Wireless LAN Connection
❏ If the printer's Obtain IP Address setting is set to
Manual, the IP address you manually set is invalid
due to out of range (for example: 0.0.0.0). Set a
valid IP address from the printer's control panel or
by using Web Config.
E-9
Solutions:
Check the following.
❏ Devices are turned on.
❏ You can access the Internet and other computers
or network devices on the same network from the
devices you want to connect to the printer.
If still does not connect your printer and network
devices after confirming the above, turn off the
wireless router. Wait for about 10 seconds, and then
turn it on. Then reset your network settings by
downloading and running the installer from the
following website.
https://epson.sn- Setup
Related information
"Connecting to a Computer" on page 106
U
E-10
Solutions:
Check the following.
❏ Other devices on the network are turned on.
❏ Network addresses (IP address, subnet mask, and
default gateway) are correct if you have set the
printer's Obtain IP Address to Manual.
Reset the network address if they are incorrect. You
can check the IP address, subnet mask, and default
gateway from the Network Status part on the network
connection report.
114