Adding Another Workstation - Epson Gemini User Manual

11. For each procedure listed in the Permissions section, select
allow the user to perform it) or
performing it).
12. Click the
Create
13. On the last screen, click
(to return to the job list).
Close
To change any user permission settings, follow steps 1 through 7 to access
the User Settings screen as necessary. Then change any of the permission
settings on the line for the user and click
To delete a user login, click the

Adding Another Workstation

If you want to set up an additional Macintosh workstation to print with
the Gemini, you need to connect it to the appropriate network
configuration, install the workstation software, and calibrate its monitor.
EPSON recommends that your studio's system administrator install
the Gemini workstation software.
Before you install the workstation software, make sure your network and
workstation are ready, as follows:
• The workstation must be connected to the network router or hub with
cables you have provided.
• The workstation must meet these requirements:
• G4 or iMac
• OS 9.x (9.1 or higher recommended)
• 512MB or more of RAM
• 40GB or larger hard drive
• 1024 × 768 or higher screen resolution
• While not required, we recommend using a CD-RW (read/write)
drive for archiving your photos on CD-ROM.
For details, see the EPSON Gemini Pre-Installation Planner provided to
you before your Gemini system was set up.
(to prevent the user from
Deny
button, then click
OK
(to return to the User Settings screen) or
Return
Delete
™
with a 500 MHz or faster CPU speed
Adding Users or Workstations
Permit
at the next screen.
.
Apply
button on the line for that user.
(to
A-3