Replacing An Ink Cartridge - Epson Gemini User Manual

Replacing an Ink Cartridge

Black and cyan
ink out lights
Operate light
6-20 Maintaining the System
If an ink cartridge is low on ink or empty, you see an alert message on
your workstation monitor. To check your ink levels before a message
appears, use EPPMonitor, EPPStatus, or EPPServer, as described in
Chapter 3.
You can also check if an ink cartridge is low on ink or empty by looking at
the printer's control panel, shown below.
light flashes, the cartridge indicated by the H light is low
When the
Ink Out
on ink. When the
Ink Out
H light is empty and you need to replace it.
Don't remove an ink cartridge unless the Ink Out light is flashing
or on, or unless you'll be replacing it with a new one. Otherwise the
ink counter won't be able to tell you how much ink you have left.
Use only the following EPSON ink cartridges:
• Black:
• Cyan/light cyan:
• Magenta/light magenta:
• Yellow:
See page 5-3 for instructions on ordering replacement cartridges.
To ensure good results, use genuine EPSON cartridges and do not
refill them. The EPSON inks have been specially formulated for your
system, and the system printers have been specially profiled for
those inks. Other products may produce inferior images, and may
also cause damage to your system not covered by EPSON's
warranty.
Always leave the empty cartridge installed in the printer until you are
ready to replace it with a new one.
light stays on, the cartridge indicated by the
T537120
T537220
T537320
T537420
Ink Out light
Magenta and
yellow ink out
lights