Advertisement
Figure 5
14. With the help of another person, hold the collet
closer in position with the fixed seat against the
headstock. Note: The bearing shaft should be
centered in bearing body (Figure 5).
15. Once the location of the fixed seat has been
determined (should be similar to location shown
in Figure 6), use a transfer punch to mark the
location of the four mounting holes.
Figure 6
(measurements shown for reference only; your
lathe model measurements may vary slightly.)
3.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET.
Some parts are shown for reference only, and may not be available individually.
16. Drill four appropriate sized holes with a 0.203
drill bit. Note: Do not drill through headstock
panel.
17. Tap drilled holes with a 1/4"-20 tap.
18. Install fixed seat to headstock with four 1/4"-20
x 3/4" hex socket cap screws, and four 1/4" lock
washers.
19. Connect and adjust all linkage so that bearing
shaft is centered in bearing body (Figure 5).
20. Place a cutter or material into collet so you can
adjust the outward flange (B, Figure 3). Turn
outward flange until you can move the lever and
it "pops" into place, locking the cutter or material
into the collet.
5
Advertisement
