Advertisement
Figure 4
14. Securely tighten two screws (38, Figure 4) to
hold base casting in place.
15. Move carriage along bed to verify that slide
moves easily and without excessive play.
Test the angle scale setting, as follows:
16. Loosen screws at each end of taper bar, (#21,
Figure 4) and rotate knurled knob (#30) to set
taper bar at 0-degrees. Tighten screws.
17. Set top slide on lathe to 0-degrees and lock in
position.
18. Attach a magnetic-based dial indicator to
carriage and indicate against tool post, while
moving carriage. See Figure 5.
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-
800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial
Number of your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET.
Some parts are shown for reference only, and may not be available individually.
19. Taper slide should be parallel to carriage
movement. If indicator variation occurs during
the carriage travel, make further checks and
adjustments as needed.
20. Reinstall cover (#6, Figure 2).
5
Figure 5
Advertisement
