Fujitsu F2MC-16L Series User Manual page 8

If a terminal program provided by Fujitsu (the ProMan
stand alone mini terminal program "mt.com") is used, the problem should disappear as soon as
the software is started.
(If "mt.com" is used, ensure that the COM1 port is initialised by the "mode com1: 9600,n,8,2"
command first. )
If a different terminal program is used which does not support this option (e.g. the
TERMINAL program of Windows 3.1), this effect can be disabled by removing the "Terminal
Reset" jumper JP 14 (see fig. 1, p 7).For jumper information and setting see page 14.
On the terminal, the following message from the evaluation board monitor should appear:
==============================================
== _____
== | |
== |----- \ /
== |_____ \_/
==
== MB90675-Board
== MB90675-controller found
== (c) Fujitsu Microelectronics, 1996
==============================================
(C) <ModeByte,ResetVector : NONE>
The ´(C)´ status message indicates that the monitor executed a "cold" reset after power up.
On following "warm" resets, an abridged headline and "(W)" message will appear.
==============================================
== Evaluation Board V1.4 / Monitor V16.5
== MB90675-controller found
== (c) Fujitsu Microelectronics, 1996
==============================================
(W) <ModeByte,ResetVector : 88,FC0046>
If a program has been downloaded, the status message will contain an address indicating the
mode byte which should be 88h and the reset vector of the program downloaded.
- 8 -
FUJITSU MB90675-Evaluation Board - User Manual
_
| / \ Evaluation
|_____| Board
| | Monitor V16.5
Version 1.4
© ©
Vers. 3.5 terminal window or the
==
==
==
==
==
==
==
==
==
==
==
© FUJITSU Mikroelektronik GmbH 1996