Technical Characteristics; Evaluation Board Resources - Fujitsu F2MC-16L Series User Manual

2.2. Technical Characteristics

Power Supply
RAM Area
ROM Area
Emulated Controllers
Serial Interface
Debug Functions
Board Restrictions
MB90675 Controller Spe-
cific Features
Table 1:
CE Conformity
The STARTERKIT_16 is conform to the 89/336/EEC - electromagnetic compatibility EEC
law. The following generic test procedures were applied:
- EN 50081 Part 2
- EN 50082 Part 2
It was tested in a typical setup using the MB2141A from Fujitsu Mikroelektronik GmbH.
Thus, it is suitable for industrial environment.

2.3. Evaluation Board Resources

The Evaluation Board was designed in order to leave as many microcontroller resources
available for user evaluation and applications as possible.
All of the I/O ports (port 2.4 - 2.7, 3.4 - 3.6, 4 - 9, A, B) are available for external use via the
on-board connectors. The other ports are available too, but already taken by the external bus
and control signals. These can be used to expand the system (e.g. additional memory).
*
I²C is a PHILIPS patent
© FUJITSU Mikroelektronik GmbH 1996
FUJITSU MB90675-Evaluation Board - User Manual
7V ... 8V, 250 ... 450 mA (normal operation), 5V/3V output
selectable, drives up to 1 A for additional devices
256 KB (including 10 KB used by monitor)
128 KB Monitor ROM
MB90675-Series
2 x RS232
1 x external controller independent)
Parameters :
9600 Baud, No Parity, 8 Data-Bit, 2 Stop-Bit
(300...38400 Baud selectable for the external port)
All functions are realised in software including Breakpoints,
Single-Step, Watch-Points
A "keyboard break" function occupies one hardware interrupt,
if enabled.
Software:
INT9 can not be used, because it is needed for the breakpoint
system implementation.
Hardware:
Ports 0, 1, 2.0-2.3, 3.0-3.3 and 3.7 are used for the external
bus system and are not available as general I/O-Ports.
- UART (2 channels)
- 2 x 8-bit PPG timer
- ICU (4 x Input Capture Unit) - I²C interface
- OCU (8 x Output Compare Unit)
Technical Parameters
compatible (1 x controller
- A/D converter (8 x 10/8 Bit)
- 2 x 16-bit reload timer
internal and
*
- 9 -