Brinkmann 810-3331-F Owner's Manual page 11

3 burner gas grill
Table of Contents

Advertisement

Available languages

Available languages

MATCH LIGHTING THE MAIN BURNERS:
1 . Open lid before lighting .
2 . Make sure all control knobs are in the "OFF" position .
3 . Place a paper match in the end of the matchlighter . Strike the match
and place through lighting hole in the left hand side of the grill to
approximately 1/2" (1 to 2 cm) from the burner.
4 . Turn on the FAR LEFT burner control knob to the "HIGH" position . The
burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure .
6 . Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the "HIGH"
position .
7 . If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply . Turn off the gas at the burner and cylinder . DO NOT attempt to operate the grill until the
problem is found and corrected .
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual .
LIGHTING THE SIDE BURNER:
1 . Open lid before lighting side burner .
2 . Make sure control knob is in the "OFF" position .
3 . Push and hold down side burner control knob and SLOWLY (2 to 3
seconds) turn to "IGNITE" . You should hear the igniter click .
Note:
Step 3 may need to be repeated 2-3 times to light side burner .
4 . If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure .
5 . If burner does not ignite using the igniter, see "Match Lighting the Side Burner" section .
6 . To turn off, turn control knob clockwise until it locks in "OFF" position .
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual .
MATCH LIGHTING THE SIDE BURNER:
1 . Open the lid to the side burner before lighting .
2 . Turn the burner control knob to "OFF" .
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4 . Turn the side burner control knob to the "HIGH" position . The burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure .
6 . If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply . Turn off the gas at the burner and cylinder . DO NOT attempt
to operate the grill until the problem is found and corrected .
Note: If burner does not light or flame is too low, See "Trouble Shooting"
section of the owners manual .
Note: Observe flame height when lit: Flame should be a Blue/Yellow
color between 1"–2" when burner is on "HIGH" .
See section in manual on burner adjustment to adjust flame.
Lighting Hole
Matchlighter
SIDE BURNER
LE BRÛLEUR DE CÔTÉ
Read Instructions Before Lighting:
1. Open lid during lighting.
2. Push and hold down the IGNITION
BURNER control knob and turn SLOWLY
(2 to 3 seconds) to "HIGH". You should
hear the ignitor click.
SIDE BURNER
3. If ignition does not occur in 5 seconds,
LE BRÛLEUR DE CÔTÉ
turn the burner control "OFF", wait
5 minutes and repeat lighting procedure.
MAXIMUM SIDE BURNER
WEIGHT = 15 lbs
Veuillez Lire les Instructions
POIDS LATÉRAL MAXIMUM DE
Avant l'Allumage:
BRÛLEUR = 6,8 kg
1. Ouvrez le couvercle pendant l'allumage.
2. Appuyez sur le bouton de commande
de l'ALLUMEUR DU BRÛLEUR et
maintenez-le enfoncé et tournez
LENTEMENT (2 à 3 secondes) pour
« ÉLEVÉ ». On devrait entendre le bruit
de l'allumeur.
3. Si rien n'arrive après 5 secondes,
placez le bouton de commande à la
position « ÉTEINT », attendez 5 minutes
pour permettre au gaz de se dissiper et
répétez la procédure d'allumage.
10
IGNITION BURNER
l'ALLUMEUR DU BRÛLEUR

Advertisement

Table of Contents
loading

Table of Contents